Remove the 2 screws fastening the printhead to the carriage. Printing will resume 3 seconds after the lid is replaced. Dot Matrix Printer Paper. Heading 2 This is an example of the content for a specific image in the Nivo slider. Remove the cabinet lid and ribbon cartridge. Check printhead gap see 5.

Uploader: Vitilar
Date Added: 17 December 2007
File Size: 59.7 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 66131
Price: Free* [*Free Regsitration Required]

Too small a gap causes ribbon smear. In the early ‘s, the electronics industry had undergone incredible changes and as such, much of the technology had grown leaving early ‘s components by the wayside. Heading 3 This is an example of the content for a specific image in the Nivo slider.

Repeat steps 2 and 3 for the leftmost roller segment and the roller spring tensioning screw on the left side plate. TallyGenicom Dot Matrix Printer.

Clean the tip of the printhead nose where the printwires extend from the printhead with an alcohol wetted napkin. Don’t show me this message again. Transmission to the printer should be block structured less than characters per block with ENQs issued at the end of each block to check for transmission errors in the preceding block requiring retransmission and buffer availability for the next block.


If not, check transformer wiring see 2. The item may have some signs of cosmetic wear, but is fully operational and functions as intended.

Craden Peripherals Dp6 Dot Matrix Printer

Remove the cabinet lid and ribbon cartridge See 5. Check printhead gap see 5. If the new cartridge has a plastic ribbon shield attached, remove it.

Move the carriage to its rightmost position and repeat step 3. Page 22 All commands and characters received except immediate status requests, display and reset commands are placed in a first-in, first-out input buffer of 3K DP6 or 11K DP7 bytes.

Ramp adjustment screw Move ramp this way to lower gate View: The DP7 uses shorter screws on the side closer to the transformer. Check that the power switch on the printer rear is off “0” side depressed. Do not use harsh, abrasive cleaners. Used, in good looking shape.

Craden DP6 Standard Dot Matrix Printer

To print the manual completely, please, download it. The label on the back indicates the current setting. The characters must not be control characters and there must be exactly 16 displayable characters.


RS n inserts n blank spaces into the print line and craaden be used to reduce the number of characters transmitted when large blank spaces are to be printed. This item may be a floor model or store return that has been used. Color Dot Matrix Printer. Carriage drives into the right side of the printer. Assemble the 4 screws to the new motor.

Cradenn C to enable commands used with previous versions of this printer. ESC SI stops double height printing.

Craden DP6 Standard Dot Matrix Printer | eBay

InCraden delivered its first DP4 passbook printer and changed the banking industry’s printer landscape forever. This manual also for: Carriage Drive Belt 8. Page 34 The cabinet can be cleaned with a damp cloth and a mild, liquid soap or detergent. Carefully install the motor in the box and fasten but do not tighten the screws. Remove the 2 screws fastening the printhead to the carriage. No ratings or reviews yet.